For sale we have a GIVI D129S aftermarket tall windscreen for the 2001-2005 Yamaha FZ1.
Details here: FZ-1 '01-05' : YAMAHA FZ1 WINDSHIELD
The windshield is about 17" tall overall and about 14" wide max. It is in great condition, no major blemishes or transparency issues.
I would put...
Only down side I can see to putting EXUP back on is that at some point it will "clank" at idle-ish rpm's.
Otherwise, we've done several mods to our 2005 FZ1 (Holeshot hi-pipe, carb kit, timing advance, etc.) and have left that in place.
.
FWIW at this point...
We did a HoleShot full jet kit (along with air-injection removal), and HoleShot high-pipe, and Holeshot timing advance (which lets you still use regular octane).
We followed the supplied chart recommendations for altitude-vs-jetting.
Very happy with the results...
We recently had the same prob on her 2005 FZ1, also with oil filled to proper levels in sight glass.
She bought an extended warranty, so I made the dealership change the sending unit under warranty.
Problem gone!
:)
For a while, I was worried it may be an oil pressure problem, but...
Had a chance to ride the FZ1 yesterday with the ss washer mod....
...OMG ! ! !
BIG difference!
Soo much more stable in the corners, and is also less 'twichy' on the freeway (forks lowered).
.
We did all HoleShot stuff on her FZ1 (which I now ride), and it all works well together.
> High-pipe (we left the rear pegs, brackets off; less weight = go faster)
> full carb jet kit
> timing advance
> air injection removal kit
Those four items yielded 129hp on the dyno.
Love...
Washers installed. Werkz even better than the stock washer flip!!!
Thanks again folks for the tip! :tup:
Now.... to find a cheap fix/replacement for that foam-rubber uber-squishy foot-peg insert... Anyone yet try to fill the air void with leftover RTV sitting around the garage/basement?
.
I did the rubberized washer-flip thing last night on the GF's 2005 Gen-I FZ1. It made a big difference right away! Yes, there's still a bit of flex, but no where near as much.
I'll be off to buy some washers after work today, hope those work on the Gen-I's!
Does the FZ6 footpeg...
I know this is under Gen-II mods, but does the footpeg rubber replacement also work on Gen-I's? Are Gen-I and Gen-II stock pegs the same?
:confused0024:
I'd love to replace my sooper-squishy ribbed rubbers for something else!
.