flash

Hi all, I have recently bought an 09 FZ1 and I love it :). I have a question about having the ECU flashed though. I have read a lot of threads on here about getting the Ivan flash done but I seen to think that I will need a Power Commander too. Is this the case or can I just get the ECU...

Hi, Yesterday i did a free run on a mobile dyno. I'm pretty happy with the numbers but i noticed that the air/fuel is a little rich in the midrange. Is it worth it to modify the map? Should a optimized A/F gives a stronger midrange power? Further there are no complaints and the bike. It goes...

Hello everybody I recently purchased a 2006 yamaha FZ1 and i was hoping this wouldnt be my first post but sadly it is. The bike has an upgraded sprocket and an ecu flash. I was merging onto the highway in first gear, had to accelerate because of traffic and and i look down at my speedo and i...

Hi, This summer I ecu flashed my 07 fz1 here in Sweden (ecunleashed). I made the Lars airbox mod and installed a k&n filter, then took away the catalytic converter. It already had a slipon before. The dealer did the flash and made fuel adjustments for these mods mentioned. It goes great with...

new fz-10 with 3/4 hindle and flash sounds mean https://youtu.be/XW8rWpuTpokhttps://youtu.be/XW8rWpuTpok

This is advertised as a cat-eliminator slip-on, but the catalytic converter is welded into the end of the header pipe. This would actually be an "EXUP Eliminator", but after I contacted them they don't seem to care about changing the ad. Their parts seem overpriced anyway here is the ad -...

hey all, Who are the go-to guys in Australia for an ECU flash for an FZ1? I see everyone on here talks about Ivans in the US, but with postage, insurance, and the terrible exchange rate, the cost is insane. Has to be someone in Aus who has built a rep for the FZ1 by now?

Hi Guys, My first post. I owned my FZ 2007 for 5 years now. It's a brilliant bike but after an earlier upgrade with Leovince GP PRO and 16 and 46T sprocket it's time for more. I have the following two scenario's in mind: Above setup + Dynorun and ECU Flash @ local dealership + Airbox...

I can improve my confidence in leaning through adjusting the suspension, setting the sag and replacing the rear tyre with a 55. I am seeking assistance with the adjustments, and will wait until the present rear tyre has worn out before changing it for a taller profile. There is also the...

Ok Ok I'm sure this has been asked I am currently changing over my tail light and signals over to LED. So here's my ??? do your have to put resistor on them I know the reason is to slow the flash rate but is that all it's for or will it hurt the electrical system if I don't.

So I've got some orders coming in the mail, a Yosh R-77 full system with CF can and a K&N air filter. I'm going to mod the airbox and send the ECU to Vcyclenut for his $50 flash. I don't really care about getting every last HP out of the bike, just want better sound and a little more snap. Any...