I never even knew about the cult family this bike has. I went to a bike night in College Station yesterday and there were several people who came up and welcomed me to the family. I learned a couple of things, such as this forum being great, and some guy that does an ECU flash, to fix some...
Like the title says.... I'm seeing Motorcycle Gear, Free Shipping, & HD Video Reviews - RevZilla
Its shows same fit for both.. I found a different one listed for somewhere else for FZ8 that I want... Just making sure it will bolt up
Thanks
I see a lot of magnetic oil drain plugs on ebay and other online retailers. Many of those come pre-drilled for safety wire, which is what I'm really looking for to get my bike ready for track day (drilling my own may be a pain). All of them seem to be made out of aluminum though. Has anybody...
Ok, so I went today to wash, clean and lube the chain and then do my first oil change.
At first while doing the oil change, I thought the manual was referring to the drain bolt as being on the right side. Near the oil view hole, just in front, there are a couple of bolts. One is labelled 7...
One of the bolt holes has a slight crack from where the PO overtightened it, does not effect functionality at all and not noticeable when bolt is in place, no scratches.
Due to the size, would prefer local pick up to Richmond, Va.
$100 plus shipping.
Hey everyone,
I laid down my bike and broke off the right foot peg. Not wanting to get an aftermarket rearset, I opted to buy the parts needed and just rebuild what I have. Which seems to have been a mistake.
How the heck do you get this together??
OEM Stand / Footrest
# 29 Bracket...
In a failed attempt to remove my front wheel today, I was stopped because I didn't realize the hydraulic line bolt had a backing nut on it. I could not slip the wheel past the calipers. As I put it back together so that I could come and whine about it here, I noticed that the 6mm bolt has a...
Many of you probably have run into the issue of trying to remove the rotor bolts from the GenII wheels. Lots of guys I've asked have had no issues at all but I found that removing these stock torx head bits to be a royal P.I.T.A. I had tried at first with heat from a torch but probably didn't...
I was planning to fit a KAOKO cruise control thingy to my bike this weekend but it didn't go as planned. It seems that for some reason my bike doesn't have what are supposed to be standard bar end or fixtures. The KAOKO and the parts diagrams all indicate it should have some large diameter...
Hi guys just a question on the bar ends. Ok I have standard bars on the bike (2006 FZ1n) with R&G weighted bar ends, there's a 4mm hex bolt that holds them on. On removing the bar end there's the m6 bolt hole in the end of the bar that holds the bar end weight.
My question is, can I remove...
I have a 2006 FZ1 with Aftermarket frame sliders. I have yet to find which ones they are but that is irrelevant. What is relevant is that my hex bolt broke from me trying to tighten it more than necessary. I drilled it and used a reverse thread drill bit to take it out. Now what I need to know...