Search results

16T front sproket Hi Guys Sorry, not so tech savvy, but if u change front sprocket, will speedo not read incorrectly :confused:(and will u need a speedo healer?) Will there b any benefit in just changing front sprocket form 17T to 16T and leaving rear sprocket std (45T)

Hi All Need some advise, can I put either R6 or R1 fork boots (for radial calipers) on std FZ1 forks. Will they fit or do they need to be modified? Many thx

Hi All Have a 07 model and looking to replace hideous:shoot: std silencer with aftermarket slip-on that's not too pricey (10.00 ZAR to $1.00 exchange ratio) Have been looking at the Vance & Hines CS One Slip-On Muffler Black (45511) for $483.00. Like the matt black look which would go...

Hi Cobalt, I'm from South Africa, but have an American sourced bike. Many thx 4 help.have a 07 model with a PCV only (otherwise std). engine management stays on even after starting bike. Did as u explained and got following codes 2 - 84 5 - 75 6 - 73 8 - 0.6 20 - on 61 - 30 removed all codes as...

Good day all Have a 07 FZ1 with PC5 (no other engine mods) and 6900 miles on clock.Went on a b/fast run on Sun (100 miles 1 way). Need advice on following. On way there had no probs (besides freezin my nuts off-no rain).Left destination at about 11am (weather had cleared up). On way...

TPS position pics Can some1 pls post pics of where TPS is situated (not technically minded):doh2:would like to make changes as even with a PC V,still getting some throttle snatch thx kindly Ne quid nimis (nothing in excess) 07 FZ1 (pc V)

Hi Scottyd Where can I buy me 1 of them and how much? (not mechanically minded)

Hi All Took bike for longish (100 mile) ride on Sat with minister of home affairs (Wife).Ave outside temp was approx 30C(bike temp was fairly high at 123c). stupid ......... alarm caused bike battery to run flat.Could pushstart bike,but bike would not idle (just died). had to pushstart 2 - 3...

speaking greek to me, sorry don't know how,just got dyno graph from installer (will scan and attach).Do know installer is approved by power commander.:embarrased:

Hi All Just got bike back from having power commander (v) installed.Dyno figures before was 125.94 hp too 134.39 RWHP and torque goes from 76.2hp to 88.4hp R these no's correct, bearing in mind that bike is stock std except for power commander,seems a little high for just a PC V and nothing...

Hi all New to forum,recently bought 07 FZ1 (II) have questions -How much of a difference does it make (power wise) in modding airbox (with BMC filter?Is it worth it? -same question regarding velocity stacks? -Does blocking off AIS only apply when running a pipe/system? -Is there any benefit...