Recent content by Blacksport

SOLD!! Looking for a 650 Yamaha twin or 750 Honda 4, for a café project...

I sold all my cobalt blue parts for $600

I'm getting lots of inquiries about the original stock parts...... All stock parts have been sold; forks, rear shock, body kit, front brakes... Lucky you!....here's another photo

Not sure if my replies are going out; if you sent me a message and didn't get a reply, call me weekdays at work: 954-771-9277 2 more shots.....

Here's another shot

07 FZ1, 9400 miles, in near perfect condition, meticulous adult owned and ridden, no wheelies, gently warmed up each ride, rarely taken over 5-7000 rpm, garage kept, ridden on South Florida weekends, no engine mods, valves CAREFULLY adjusted around 7500 mi, motorcycle Mobil 1 only, NGK Iridium...

Two quick points: I considered Valtermoto for a few seconds, until I saw the shift rod did not go thru the frame....inexcusable IMO. About the finish on Ottimoto rearsets: When I converted to Ohlins forks, the 07 R1 master cylinder I bought used and rebuilt was so faded it now looked dark...

Good write-up; pretty much agree with everything you said. I personally didn't like the footpegs and wanted folding footpegs, so I adapted Rizoma folding pegs, welding them onto the Ottimoto footpeg stub. Also changed the toe shifters to ribbed rubber (Kawasaki), which are longer and softer than...

Someone asked about a price to Australia, don't know if my response was sent. It's $115 to your door, sent US Postal Service (USPS), much cheaper than UPS or Fedex.

What, you still have that Nimitz-class stock exhaust on your 06 or newer FZ1? Well, you can stop all the smirks and giggles from your FZ1 peers right now for a lousy 150 bucks, shipped to you free, in time for Christmas. This Yoshimura TRC stainless slip-on has maybe 4000 miles on it. Brite...

I'm on this forum too, once in a while.

The wheels have the exact same part number, front and rear. That doesn't mean the rotors, cush drive, axle, or bearing ends are the same. But the wheels are exactly the same, so an aftermarket R1 wheel will fit an FZ1, I talking about 06 or newer, not sure about older.

All R1 forks (04 or later, I think) will fit the FZ1 clamps. FZ1 brakes will not fit these forks. Look for 07 or later forks so you can use the 6-piston R1 caliers, very cool. You should be able to get R1 calipers and a master cylinder for a couple hundred bucks on ebay. If you really want to...

Check out Military-Graphics.com. Look under Badges & Misc page 4

Why mess with those? If you want 6 piston calipers, use R1's.