heresmymind
Member
I pin-striped my bike to a "TRON" style theme...
-B
-B
What did you do to your Non-FZ1 motorcycle today.
- Thread starter johnnyontherocks
- Start date
Hellgate
Wizard
Installed my "Mandlebar" stickers.
Lonney
Wizard
My Chinese jack blew out and the big girl fell off the sidestand and did not fall !!
GOOD GIRL !!
Sent from my iPhone using Tapatalk
Dustin
Moderator
Brutal! Hope there's no damage
Hellgate
Wizard
Which stand was it?
Lonney
Wizard
Lonney
Wizard
Well i seen Doug ( one size ) tip his Hondaponamas over so i tried it thanks Doug !!
http://images.tapatalk-cdn.com/15/07/01/2054fe0258c59e65c7117756c1b94223.jpg[/IMG
Ha Ha im done for the night no damage just some broken fairing rivits
The cycle gods were with me today !!
Sent from my iPhone using Tapatalk
Ha Ha im done for the night no damage just some broken fairing rivits
The cycle gods were with me today !!
Sent from my iPhone using Tapatalk
Lonney
Wizard
I hit 5.000 miles on the super ten so I put a new filter and Amsoil and I removed cleaned and lubed the shifter assembly .
n.e.mich
Wizard
Swapped out the 44t for a 42t, lost 6-700 rpm at highway speed. Perfect for the longer rides...
Hail
Moderator
Purdy that is!
n.e.mich
Wizard
Replaced the factory steering head/stem ball bearings with tapered roller bearings last night. That was 2.5 hours of no fun. lolol
n.e.mich
Wizard
Gave it a nice bath today, had grease and hand prints all over it.
Ahhhhhh
Ahhhhhh
Lonney
Wizard
Spent the night in lake Ariel PA ( its up near Scanton PA ) it only took me two hours to get home !! 160 miles
Sent from my iPhone using Tapatalk
Lonney
Wizard
Rode the supen ten for four hours and 140 miles for a total of six hours and 300 miles today.
I started off 6:00 am 52* f Now its 90* f i was freezing this morning in mesh gear !!
Sent from my iPhone using Tapatalk
I started off 6:00 am 52* f Now its 90* f i was freezing this morning in mesh gear !!
Sent from my iPhone using Tapatalk
heresmymind
Member
spent 10 minutes and installed AIS block offs on the fz8
-B
weight savings: 1/2lb ~ 23.8hp
-B
weight savings: 1/2lb ~ 23.8hp
n.e.mich
Wizard
Finally repainted (epoxy) the garage floor!
Oldschool
Moderator
Finally repainted (epoxy) the garage floor!
Ooh, purdy!
If my garage floor looked that nice, I might never go in the house.
n.e.mich
Wizard
I do spend a lot of time out there!
Lonney
Wizard
Finally repainted (epoxy) the garage floor!
It looks great what did you use.? Did you have to etch the concrete)
Sent from my iPhone using Tapatalk
n.e.mich
Wizard
These are the cleaners/paint/sealant I used:
I used the Rustoleum 2 part epoxy paint kit last time and really wasn't impressed with the short time it lasted. This way was a little cheaper but we'll see if it holds up. Ended up using 2 1/2 gallons of paint (2 coats) and 2 gallons of sealer (2 coats). I bought the cleaner and paint at Home Depot and had to buy the sealer at Lowes. Home Depot and Menards only carry the Rustoleum brand of gloss sealer which is much more expensive.
I used the Rustoleum 2 part epoxy paint kit last time and really wasn't impressed with the short time it lasted. This way was a little cheaper but we'll see if it holds up. Ended up using 2 1/2 gallons of paint (2 coats) and 2 gallons of sealer (2 coats). I bought the cleaner and paint at Home Depot and had to buy the sealer at Lowes. Home Depot and Menards only carry the Rustoleum brand of gloss sealer which is much more expensive.
Last edited: