Sorry for not posting those pics the crappy thing about work is well it gets busy at the worst times -- None the less glad you got your plug hot and installed
Next time I do get around to taking the front of the bike apart I will take the pics anyway just for future ref for anyone looking to...
troyw, the extension did not seem to cause any issues after I put the plugs in the AT everything started to work, I have seem some articles that the AT has a digital ground issue and that the TPS is really jumpy on our bikes and we should tie into the digital ground of our sensors and this will...
I was unable to get to this today, I will for sure get you the wire I tapped into tomorrow, I even have it on my list of todo's :D
Sorry for the delay..
I will try to take some pic's tomorrow of the wire I tied into - I tested for a wire that was only hot when the key was on that way the plug is dead when the key is out of the bike - for the ground there is a screw that screws into the frame that I tied into so the hot wire is the only one you...
Agree I went to a local cycle shop and picked up an ATV outlet have not had any issues charging my iPhone while listening to iTunes or SIRIUS Satellite Radio or Talking on the phone
Pic's of my 12v socket installed
Copied from the thread linked in this thread:
Hold down both SELECT & RESET
Switch on Ignition
Display will show HI flashing (5sec)
Release buttons
Display will show d1
Hold down both SELECT & RESET for 5sec
Display will show d:01, 16
Press RESET till display shows d:63, 00
Press...
Another question about the plug, did you install both plugs (One for the left over Auto Tune port and one for the left over PCV port)? or just one plug on the Auto Tune?
Now I feel really dumb I just went to re-read the autotune instructions and it says the following:
To verify that Auto tune is working you should see a real time AFR reading in the lower right hand corner of the software. A value of 9.99 could indicate a faulty sensor or the sensor wired...
Well I kinda feel dumb now LOL, the Power Commander V plugs are in fact just a little rubber stopper however the plug for the AutoTune does in fact terminate the bus and after installing the plug the A/F started to show up
Thanks for pointing me in that direction I was going to install them but...