mbnwa
Member
Ok so I spent most of today installing the Power Commander V + Auto Tune on my 2006 FZ1 now I have 3 questions
First - I am getting Error 76 every now and then and can not figure out what that error is
Second - How can you tell that the O2 is actually doing something, I had to make the harness longer due to how sort the thing was I soldered the wires and put heat shrink tube + wrapped it in electrical tape however in the Power Commander V App the A/F1 shows 0.0000 I'm not sure if the software shows the A/F mixture from the Auto Tune or if I now have a brick O2
Third - Any suggestions for getting a good base map for PCV with the following mod's done - Files removed, Stacks Installed, Scorpion Slip On, Air Box Mod
Thanks for any help or and pointers in the right direction.
First - I am getting Error 76 every now and then and can not figure out what that error is
Second - How can you tell that the O2 is actually doing something, I had to make the harness longer due to how sort the thing was I soldered the wires and put heat shrink tube + wrapped it in electrical tape however in the Power Commander V App the A/F1 shows 0.0000 I'm not sure if the software shows the A/F mixture from the Auto Tune or if I now have a brick O2
Third - Any suggestions for getting a good base map for PCV with the following mod's done - Files removed, Stacks Installed, Scorpion Slip On, Air Box Mod
Thanks for any help or and pointers in the right direction.
Last edited: