CrazyBiker
Wizard
First of all they are beeeauuuutiful!
Stock: They are 65mm tall.
Roth: They are 30mm and 70mm tall. http://riperformance.myshopify.com/products/velocity-stacks
Stock: They are 65mm tall.
Roth: They are 30mm and 70mm tall. http://riperformance.myshopify.com/products/velocity-stacks
- Remove the inner fairings, tank cover, and lift the tank
- Remove the airbox cover lid. Don't forget the center screw.
- Remove the stock stacks and take out the screws from them.
- First loosen the Roth stacks from their bases enough so that the base sits flush and tight in the airbox.
- Screw in down the screws but don't tighten them completely.
- Screw in the stacks so that they seal the inlet flush. This can be felt by your finger.
- Now tighten the base plates completely.
- Now tighten the stacks completely. You may need to 2-3 tries between this and previous step to get an airtight seal between the base plate and airbox bottom and the stacks and the inlet sides.
Last edited: