• Welcome to the Yamaha FZ1 Forums. Member registration disables ads and allows you to post and share. Register Here.

can i use a PCII from an R1 on a FZ1 07

04-06' R1 PC III will work with the Gen II FZ1 That is the model year(s) engine ours is based upon. You need to erase the R1 map and put in a map created for the FZ1 if you want it to run right.

The part numbers are 420-411 for the FZ1 and 421-411 for the R1. On the other forum, Dek and FazerMonkey have been running 421-411 units without issues.
 
Last edited:
Im running an R1 PCIII in mine. Plugs right. As stated above, you'll need to load a FZ1 map on instead of an R1 map.

Good luck!

Matt
 
can somebody help me with a map, here is what I'm running
reduced diameter to 38mm on secondary flies, remove the cat, installed a two brothers M2 slip on exhaust, lars air box mod and a K&N air filter
 
Last edited:
The 410-411 will work. It was just the model number they put out for the '05 R1. You can download the maps here. We have a thread for those. Any FZ1 PCIII map that fits your mods should work. Try several and pick what performs best for your bike. ;)

I just looked and see you found the map sticky! :D
 
You must log in or register to reply here.
Back
Top