Recent content by RiderJC

I’m having problems getting my Speedometer to read anything but zero on my 2012 FZ1. The bike had been in a minor accident prior to me owning it. The front fairing was gone, but the speedo and faring mount was sound. The speedo works as should for everything else on it, including the tachometer...

My speedometer on my 2012 FZ1 is reading zero when moving. Everything else works on the speedo. Tach is working, fuel gage, lights, but the speedo just stays at zero. Replaced the speedo sensor with a brand new one, and still the same. Zero. Took a muti meter to the speedo connector, after...

Looking for aftermarket end can and mid-pipe. 2012 FZ1

I have an 84 RZ also. I see you mentioned that you had a problem with your front master cylinder. What I did was picked up a radial master off of a 600 GSXR Suzuki. I think I used an 08’s. You will need a remote reservoir such as the rizoma. Along with the Galfer brake pads, it all works...

What do the Graves velocity stacks do for performance???

Sold Sold Sold

Gen2 08 Red Front Cowl, Headlight, & Windscreeen (Sold) Front cowl off a 08 FZ1. (Sold)

Gold wheels with rear rotor and all bearings. Tires are the original tires. A tire changing tool has never touched these rims. They are in perfect condition. The tires have three thousand miles on them, but the rear looks like it has a slice from a sharp rock or something. Doesn’t look too deep...

Anyone heard of a Cobra Fi12000 PowrPro? Hook to the Fi of the bike and they say it continuously monitors the EFI delivery 80 times a second optimizing air/fuel mixture? No Dyno needed.

I love the way my 08 FZ1 runs with the stock exhaust. Basically it runs perfect. Not a hiccup throughout the whole range. The endcan is ugly as sin, and I’m sure it weighs a ton. I’m wondering if I should replace just the endcan, or the whole system…. I’ve been reading around on the forum, and...

Do you mean "switch back to the standard front end"? It all comes off and nothing is cut or damaged. That is as long as you don't drop it.

Bolt on. I did the same mod. You go to your dealer and order everything on the micro-fiche for the 2012 FZ8 headlight, right down to all the nuts and bolts. It helps a lot of you find a dealer with a FZ8 that you can look at and take close-up pictures of it, because when you get the pile of...

My 08 FZ1 has gold wheels on it. The standard tires are still on them. So, no scratches from changing tires or anything of the sort. They are like brand new. Looking to trade for a black wheel set in as good of condition.

I’m new to the FZ1 and this forum. I know this has been the topic of discussion several times here, but in searching I run into conversations from 07 up till now, and can’t figure out which is the best (easiest) way to go for the headlight conversion. I see where the wire harness had been...