Hi Guys,
THanks for the suggestions to get the ECU reflash. I would like ot do the flash but the concern is that I am currently in Japan. Sending the ECU back even by express will be a few weeks turnaround. I cant be without a bike that long :(
I figured the iginition module may be a good...
Hello All,
I recently just added a PCV to my bike and I am very happy with it. Makes riding the bike much more enjoyable. I am now considering getting an ignition module since I have read it helps with the mpg and the bike will run cooler. Before I make the purchase I was hoping for some people...
It took awhile but I got my PCV installed. I used the map suggested by Dynojet which was the map for a Yoshinura TRC Full exhaust with a stock or aftermarket filter.
I am a newbie wen it comes to the fueling maps but noticed that the map seemed to have added fuel where other maps reduced fuel. I...
Hi All,
I am currently planning to buy a PCV for my 2006 FZ1. I currently have a Yoshi full exhaust, K&N filter and graves flies. I have not yet modified the flies, most of the maps I saw have modified flies. What is a good map for me? Should I stick with stage 2 or 3?
LOL i doubt you are that big to compress them that much. Now me on the other hand
Well I was back on the bike, but it seems I am out of commission for a while. I crashed this weekend and am waiting on possibility of repair. My fault since I crossed the center line going around a hairpin. I...
I did the swing swap today. I guess the owner before had done a fork rebuild. The oil was a red color and there were tool marks.
I also noticed the difference of spring length was no as large. The springs were only about 5mm different in length. Were the forks from a 2009 and 2006 different...
How much did you cut the spacer? I saw the post where you had to go back and cut 6-8mm. Does that mean initially you should have cut the spacer to match the new spring?
Hello All,
This week I will be replacing my stock fork springs with Racetech springs that are 1.0kg. I chose the replacement in part due to the forks needing an oil change and sine I weigh 88kg with street gear.
My rear suspension is a Matris aftermarket shock.
I am a suspension newbie...
I bought the bike about 7000Km ago and prior to that I do not have a maintenance record
The bike was given a maintenance check before I bought it. Since I have had the bike I changed the air filter and routine oil changes.
The bike did have a Ivan's FCE installed by the previous owner...
Hi Guys,
I could use some advice. I have a 2006 with 90,000km.
I think I may need spark plug changed but want to see if there may be other issues.
Recently I noticed that at times took some extra tries to start my engine after filling up the tank. No issues when the engine is cold.
Today...
Thanks for the advice on Ivan's flash.
I am still actively riding on the weekends so I cannot afford to have the ECU sent in just yet. Based on the mail it will take about a 2-3 week turnaround time.
So should I go ahead and install a power commander until it gets truly cold and my bike...
Hello Everyone,
I am new here and wanted to introduce myself. I am a former Marine living in Japan, I recently purchased a 2006 FZ1. I love the bike and take it out every weekend.
Hello Everyone,
I am new to the boards, I am a former Marine living in Japan. I recently purchased a Canadian spec 2006 FZ-1. I am told the local Japanese bikes have been detuned. I love the bike, it feels very poised and balanced.
The previous owner did work on the bike and I am continuing...