Recent content by Port8080

That's a great looking gen 1. I'm a big fan of modifying the gauges. What type of bar end mirrors are those? Sent from my iPhone using Tapatalk

Great news, the issue is fixed. I looked under the tank and this little white connector was unplugged. As soon as I plugged it back in the other two cylinders kicked on. Can anyone tell me what this connector does? Is it a vacuum? I can take a picture tomorrow if it helps. Sent from my...

Now that I think about it can I put dry gas or something along the lines of that in the tank to clear out derby build up? The bike has been sitting for a long time. That might be causing something. The bike doesn't have a lot of miles on it. At least not compared to some gen 1 s Sent from my...

Thanks for the input. Currently I'm working 7 days a week and have very little time to look at the bike though it is my primary vehicle ATM. I'm thinking I might have to take it to a shop. Sent from my iPhone using Tapatalk

Any ideas on the causes or costs to fix them? Sent from my iPhone using Tapatalk

You are correct. When looking at the front I the bike, the outer two are cold. Sent from my iPhone using Tapatalk

My wife and I were riding to the movies when all of a sudden I experienced what can only be described as a sudden loss of power to the throttle. As I rolled on the throttle after making a turn the bike was bucking slightly. At first I thought it was the road but I soon realized it wasn't...

I want to change the fuel sensor out on my gen 1. This way, my R1 gauge will stop showing the gas is low. I still have gas in my tank and didn't know if there was an a alternative to siphoning the gas out. Any suggestions? Sent from my iPhone using Tapatalk

Probably not fully warmed up because I was cutting it off as it hit 140 F. I was worries it would over heat smh. Good to know average temps. Thanks. Sent from my iPhone using Tapatalk

Great looking bike. You can find a lot of good info here. Sent from my iPhone using Tapatalk

Now that I have the R1 gauge on my Gen 1 I have a digital display of the temp. Is 140 F too hot? Also, does anyone know when my rad fan should kick on ( Temp or time wise) I have to 00-01 R1 gauge so it should function in the same manner as the FZ. Sent from my iPhone using Tapatalk

Finished building my gen 1 street fighter. Sent from my iPhone using Tapatalk

I appreciate the input guys. I think I found the problem. When I first wired the R1 gauge I mistook the "br" wire for the "ch" wire. Consequently I wired the +12v ignition to the left turn signal and visa versa. Once I wired it properly the gas leaking stopped. Just to be on the safe side I may...

Today I noticed some gas leaking out the bottom of my bike when I turned the ignition from OFF to Battery/ON. I didn't start the bike, only turned the ignition to the ON position. The bike has been sitting over the winter while I modified it into a street fighter. I just turned it to ON to see...

Oooo. Super fancy gauges. How hard was it to wire it?