Sync Time

[Missyl1713]

Crazy where'd you fun that? Everything I've ever read states not to adjust the #3 screw. That's interesting!


Sent from my iPhone using Tapatalk

 

[Missyl1713]

Find...supposed to be FIND. Dang autocorrect...


Sent from my iPhone using Tapatalk

 

[CrazyBiker]

personal experience over 2-3 syncs. If your baseline #3 is over 22, you will soon run out of adjustment on others. I FOUND OUT that if you back #3 in completely and back it out 1 exact turn it perfectly sits at 22. Then do the same for others. Bike runs beautifully after that!

 

[Missyl1713]

I think I've synced it three times, haven't had an issue yet, but really glad you said something! Good to know!


Sent from my iPhone using Tapatalk

 

[firefly]

If the carbs are out can one sync them accurately or do they have to be on the bike?
Thanks

 

[T84A]

On and bike running.

 

[waldo877]

On and bike running.

And the bike at the proper temp. not cold, not hot.

 

[rc5695]

The OLD MotionPro's used mercury. That's what I have. It works great. The new environmentally safe water-based ones suck!!!

If you look in the How-to's on this forum, I think I showed a few steps of mine. Not sure how much detail I got since it was so hard to see in there and so hot... lol. What I had the hardest time with was reaching #4 to make adjustments.

Also, what CrazyBiker said is correct. Set #3 to where it is supposed to be and then adjust the rest. It is amazing how a small adjustment will make a big difference. Also keep in mind you may nee to adjust your idle speed too, depending on how far out it is. Mine was WAY out...

 

[rc5695]

Check out posts 28 & 29

http://www.998cc.org/forum/gen-ii-h...t-seat-latch-trim-flies-airbox-mod-pc3-3.html