Show me your Gen II bars

[supersonic]

I'm struggling to find a comfortable bend handlebar on my Gen II. What are you using? Any pics?

 

[Jamieb]

I am using Renthal Road Low bars they raise and pull back from the stock bar.

 

[fullcircle]

The bars look good. Did you have to change the lines or cables to make them fit?

 

[schleppy]

I'm using the Bikemaster Superbike bars in black. They are taller than stock, and a bit less pull back. I'm still debating if I like them or not.

 

[Jamieb]

The bars look good. Did you have to change the lines or cables to make them fit?

The only thing that had to be changed were the Brake lines (which I was changing to stainless anyway) which are 2 inches longer than stock

 

[ballmead]

I'm using Rizoma Conical handlebars with 60mm risers.
They are slightly longer than stock (which helps to crank the bike over faster) and sit a little higher but with a better wrist position.
I like them alot.

 

[CorrectionsK9]

Does anyone make a black bar like the stocker?

 

[wald0]

Im using LSL Street bars and Suzuki risers.. :bowdown:

Bar has a lot less pullback than original and Risers move bar little bit more down.. i did cut bar at the ends about 3" cos did not want to have so wide bars..

 

[TKO]

I haven't mounted them yet, but I bought a set of Thar Bars that are fully adjustable for height, pull back. Heck, you turn them over and you have the same thing as clip-ons.

Here is a couple of pics on an FZ1 (not mine):

 

[redryan]

I have Pro Taper SE Carmichael bars with Suzuki GZ250 risers. They have very little sweep, which I prefer. I can't see much out of my mirrors any more, though. I plan on getting some bar end mirrors this year.