tommyp
New Member
Hello All,
I have a 2004 FZ1 1000 with 140,000kms on her and the number 1 cyclinder has a compression of only 65 psi. All the othr cylinders are fine. The valves all have positive valve clearance. Any ideas or suggestions?
Also, on the same bike, I have a few exhaust valves with .004" clearance. As I understand it, this is on the lower limit of the factory spec. Any opinions on whether I should open these up a bit or just leave them?
Thanks for any help you can give.
Tommy
I have a 2004 FZ1 1000 with 140,000kms on her and the number 1 cyclinder has a compression of only 65 psi. All the othr cylinders are fine. The valves all have positive valve clearance. Any ideas or suggestions?
Also, on the same bike, I have a few exhaust valves with .004" clearance. As I understand it, this is on the lower limit of the factory spec. Any opinions on whether I should open these up a bit or just leave them?
Thanks for any help you can give.
Tommy