Led tail & running lights

[Shcherbina1]

After spending a hour searching on goggle and not finding the information, I'm here asking for help. I just bought led turn singles and 1157 led replacement bulbs. Can some one direct me to the information I need for wiring it all together and how to get to it. Thanks

 

[ptrudel]

All the wiring is under the seat...

As to pull out the tail light;

Pop off the seat
Remove grab handles
Remove the bolts holding the colored plastic tail
And then you can get to the tail light

This is going from memory from almost a year ago, but that should get you there.

 

[Shcherbina1]

:doh2:I wound up having to remove the tail section to get to the lights, now they are twice as bright. well worth the money. I also installed 3 wire led lights for the turn singles it seams to me that I should be able to use them as running lights as well be I cant find how to anywhere.

 

[ptrudel]

:doh2:I wound up having to remove the tail section to get to the lights, now they are twice as bright. well worth the money. I also installed 3 wire led lights for the turn singles it seams to me that I should be able to use them as running lights as well be I cant find how to anywhere.

If you have 3 wires, you should just have a ground, signal, and constant...if that's the case, use the constant power supply from the tail light and you'll have running lights in your signals

 

[Marthy]

I did the same on my 6R. Running/signal lights to the rear. I hook up the running light with the license plate light and been working good. I did everything with the FE. So I pretty much cut the loom and connected everything together. When I conneced the LED license plate light... I connected the running light too.

 

[Ssky0078]

I'm about to tackle this same job.

I went with Motodynamic LED Taillight with clear instead of the smoke. I was worried the smoke lens would reduce the brightness, but I wanted the smoke for looks.