Hopefully quick question about TPS opening and closing points (installing Ivan's ECU)

[Clyde]

I've installed the flashed ECU, removed the I'M and am now to the point where I'm setting the opening and closing points. TPS didn't need to be adjusted based on instructions from Ivan.

Step 5 in the instructions says, "Looking at the throttle position readout and the rpm, gradually apply the throttle... You want the "0" to change to a "1" between 1000 - 1150 rpm (for my map)"

I think this means a 1000-1150 rpm increase, since the rpm is set to between 1200 and 1300 from a previous step. Can anyone confirm?


Sent from Tapatalk on my Note 4.

 

[ballmead]

That's a typo, it should change to 1% at around 1600-1700 rpm. You set your idle to around 1250 rpm.

Sent from my Nexus 5

 

[Clyde]

Ah, crap. That's what I get for assuming. I'll go back and re-do the open and close points.

Sent from Tapatalk on my Note 4.

 

[Ivan_IPP]

Ah, crap. That's what I get for assuming. I'll go back and re-do the open and close points.

Sent from Tapatalk on my Note 4.

I must have sent you the wrong sheet... (very sorry)

1600-1700 is correct.


Ivan