mohanraj
New Member
in my FZ1 while ignition is switched on, all display works and later after 10 seconds it becomes blank, and it shows only > d1 < kindly le me know how to solve it.....
Last edited:
FZ1 speedo meter
- Thread starter mohanraj
- Start date
CrazyBiker
Wizard
Someone may have messed up with the speedometer considering its India 
. did you buy bike the new or through grey market?
. did you buy bike the new or through grey market?
NJFZ1
Moderator
Sounds like the bike is in diagnostic mode. Here's how you access such a mode:
1) Turn key to off
2) Turn ignition kill switch to run
3) Hold the select and reset button at the same time
4) Turn the key to run
5) Continue to hold the two buttons and count to about 10 at this point the display will show "d1"
6) Release the two buttons
Getting out of it may be the reverse procedure, but I'm not sure. Maybe try disconnecting the battery for a few minutes if all else fails...
1) Turn key to off
2) Turn ignition kill switch to run
3) Hold the select and reset button at the same time
4) Turn the key to run
5) Continue to hold the two buttons and count to about 10 at this point the display will show "d1"
6) Release the two buttons
Getting out of it may be the reverse procedure, but I'm not sure. Maybe try disconnecting the battery for a few minutes if all else fails...
Bacardi_AVT
Member
to get out of diagnostic mode you normally just turn the key OFF.
NJFZ1
Moderator
Well if that's the case (and it makes sense) then he may have a bigger issue...