Fork swap question?

[CorrectionsK9]

Any advice on what should I do to square up... [_] the front forks when changing them? Just bought a torque wrench also cant wait to use it where could I find those specifications?

Thanks for any advice

Craig

 

[NJFZ1]

Just line up one fork at at time with the top triple clamps. Either flush or 5mm higher (to quicken the steering a bit). Tighten top pinch bolt, then do the bottom ones. Do the second fork in the same fashion. Make sure both are sitting the same (flush or sticking up 5mm) in relation to the top triple tree. Once the pinch bolts have been torqued to spec remove the front axle and install the wheel. Then torque axle to specs and install the calipers. Torque values below:

 

[CorrectionsK9]

Thanks NJ... I just wanted to make sure everything seated right