SETH46
Well-Known Member
Yeah everythin on the read out was done on that Dyno, same place, same guy, same gear.Might not hurt to throw some more fuel in there at the 100% throttle column at lower revs. Will you hurt your engine if you leave it like it is? Hard to tell, but since I do see that it riches up at the top end you might be ok. Still if it was my bike I wouldn't want it running that lean on the bottom end. What map are you using?
I do have to say that looking at your dyno run there it seem sto be extremely lean and it may be more a function of the O2 sensor that was used than anything else. If you look at the stock A/F ration then that's more or less what you want yours to look like (probably a little leaner). Do you know if that stock A/F ratio was done on that dyno using the same O2 sensor as well?
I'm using a map from the Duken Pack off the other site.
Using a STAGE 3 map by JonDaddy82 (everythin mod'ed but standard headers)
Might use the Dukes Perfection Map again, much richer fuel throughout the map, especially low down.
Seth