block

Hi guys - Over the past few months, I've been working on a new product for the Gen2 FZ1, and I'm getting very close to being ready to launching it. Even before having a Gen2, I never liked the options available for mirror block off plates on the Gen2. They all were compromises based on time...

Hi Has anyone painted or touched up the engine block - the previous owner sprung a leak while touring and as a quick fix used something which dried rock hard. I have had the gasket changed but some of the paint has gone with it - I was wondering if there was an easy way to make good without...

Hi guys, got an FZ1 with a rostra electronic cruise fitted. Works great but would love to fit an MT10/FZ10 left switch block to make it look more factory. Any Auto electrician here know or suspect I can interface them?

I'm planning on changing plugs soon and adding block off plates when I do. Question is can I just plug this hole in the airbox for the time being until I do the blockoff plates ? Thanks

Well, I needed new gloves. My Helds blew out on the finger tips. My Alpinestars GP Pro gloves have lots of wear. I had to use some Shoe Goo to repair the patch of crappy leather they put on the palm and thumb. Other than that, they are OK. I decided to go with the Helimot gloves. They are...

Having only 8k miles, I doubt that she needs the plugs even checked, BUT I do have the radiator pulled, and ALL the body work pulled at this point, plus I have the new plugs on hand, so I'm aiming to replace the plugs while I'm "in there." That said, I cannot get the ignition coils off & out...

Hi everyone, I've just joined FZ1 forum and looking forward to picking everyone's brains when it comes to modifying my new bike (FZ1N 2008) which I pick up this Saturday, this will be my second FZ1N the 1st being a 06 model. The bike is completely stock but for a scorpion slip on. I've...

To install these: It's much easier if you remove this: Which leaves plenty of room like this: And with the use of this tool: Used like this: It makes removing this: A 5 minutes a side job which now looks like this: If you are thinking of doing the AIS block off, do it at...

Hey guys, last month I got myself a very clean 2012 FZ1 naked with a full yoshinura R-77 exhaust installed. I´m planning to add a PCV and K&N filter. But in the meantime, I would like to block the AIS to cut off on the popping. The question will be, what is the easiest way to do this without...

Sitting around watching TV so I decided to make an extra power distribution block. With mine and the wife's I crimped inline fuse holders into the output line directly. Up to 4 and I ground all the accessories to the frame utilizing the shortest ground possible. All ready to rock just wire...