torque specs FZ1 GenII

DenArnold · Jan 2, 2013

handy to print this and put on the wall in your garage next to your FZ1

speeddemon2588 · Jan 2, 2013

Thanks for the info. Where did it come from?

DenArnold · Jan 2, 2013

info extracted from the manual and my Yamaha dealer

CrazyBiker · Jan 2, 2013

I don't use a torque wrench for anything below 35 ft-lb. Just hand tighten it by feel. Have stripped a few screws using a torque wrench.

Mdala · Jan 2, 2013

150 Nm for the rear axle nut seems a bit over the top, I use about 110. Just saying.

CrazyBiker · Jan 2, 2013

150 NM ~ 110 ft lb is fine if a bit tighter than most.

romr · Feb 20, 2013

Mdala said:
150 Nm for the rear axle nut seems a bit over the top, I use about 110. Just saying.

Really? I want to put 350! I do not want that damn thing coming off at 100mph. I do use 150 but I make sure it clicks twice.