Fastas
New Member
Hi can anyone help I am looking for a circuit diagram that shows the indicator circuits for a FZ1N.
I am trying to install a StopIt! indicator reminder on an FZ1N.
The StopIt! has three wires.
The black wire normally goes to the -ve (ground/chassis) wire on the indicator relay.
The black/red wire normally goes to the intermittent positive wire that
leaves the indicator relay and goes to the positive side of the indicator lights.
The third wire goes to the positive side of the brake light circuit. When the brakes are applied the positive feed into this wire mutes the StopIT!
However there are only two wires on the indicator relay and when you apply the brakes the StopIT! does not mute.
If I had a diagram I am sure I could sort this out in a couple of minutes.
Can anyone point to one on line?
I am trying to install a StopIt! indicator reminder on an FZ1N.
The StopIt! has three wires.
The black wire normally goes to the -ve (ground/chassis) wire on the indicator relay.
The black/red wire normally goes to the intermittent positive wire that
leaves the indicator relay and goes to the positive side of the indicator lights.
The third wire goes to the positive side of the brake light circuit. When the brakes are applied the positive feed into this wire mutes the StopIT!
However there are only two wires on the indicator relay and when you apply the brakes the StopIT! does not mute.
If I had a diagram I am sure I could sort this out in a couple of minutes.
Can anyone point to one on line?
Last edited: