I've seen a few questions over the years about how to check float bowl heights.. When I had my Gen 1 and did my Holeshot jet kit, I made this template. One of the FZ1OA guys shared something like this and I drew it up. Drawing attached. This one is set up to check for a float height of 13mm, per my Holeshot instructions. If you need a different height, for a different kit, adjust the 13mm dimension accordingly.
To make one of these, you take a 3x5 index card and VERY carefully mark it up, and cut it with a razor, to try and keep it as accurate as possible...
To make one of these, you take a 3x5 index card and VERY carefully mark it up, and cut it with a razor, to try and keep it as accurate as possible...