Search results

  1. Blanchy

    Anyone still here?

    Mines shortened Blanchard. We'll have to hook up for a ride then. See you like two strokes too!
  2. Blanchy

    Anyone still here?

    Gday mate, just down the road.
  3. Blanchy

    Cruise Control

    Cables can stay in place. Just remove the 10mm nut off the flat sided shaft. use the flats to key in your actuator. You got a 3D printer? That would be fun
  4. Blanchy

    Cruise Control

    Honestly can't recall?
  5. Blanchy

    Cruise Control

    Min speed for steady cruise is about 90kph 53mph? Below that its unreliable. Get the stroke as long as possible. Mine was only restricted by the throttle body bracing. PPM was advised by Norbert at Heal Tech that do Speedo Healers he also advised cruise to be wired in before the Speedo Healer.
  6. Blanchy

    Cruise Control

    Insert from the front.
  7. Blanchy

    Cruise Control

    I put mine in upside down in the exup spot. perfect fit. The slack I set where the cable exits the Rostra unit, slacken the torx screws on the cable "boss" and measure the gap there with a finger on the throttles to check for movement. I connected mine to a crank off the side of the throttle...
  8. Blanchy

    Drag racing

    I'm using a 16t front but looking at my top speeds, going to go back to stock.
  9. Blanchy

    Gen 2 how to clean fuel filter

    Are replacement filters available?
  10. Blanchy

    Cruise Control

    All but 7,8 & 9 Mine set to V8 low to take some sensitivity off, I figure a V8 will require a lot less throttle movement/speed than say a 1.6l car to keep speed constant so I have 7 8 & 9 set off
  11. Blanchy

    Cruise Control

    Somewhere in my garage. I'll have a dig around. Very important to have the cable slack exactly.
  12. Blanchy

    Show us your fz.

    Nice...................
  13. Blanchy

    Show us your fz.

    Thanks but I really recommend a Full Yoshi and quick shifter. Makes the bike!
  14. Blanchy

    Show us your fz.

    Looks great. I am still thinking of getting my spare body kit painted like that.
  15. Blanchy

    Anyone still here?

    I thought is was me
  16. Blanchy

    Anyone still here?

    Supposed to be autumn here but hiding in the air-con 38 deg C 100 f here today.
  17. Blanchy

    Drag racing

    1.951 had a bad r/t .432 as it was on a pro tree
  18. Blanchy

    Drag racing

    Full Yoshi, BMC Filter, Ivans Flash, Quick shifter are the main ones.
  19. Blanchy

    Drag racing

    After a few tries, I finally broke into the 10sec bracket with a 10.88 pass. Happy as.
  20. Blanchy

    Anyone still here?

    Call out, still around?
Top