matt, always look for the easy things first, side stand cutout switch? clutch switch? is the FZ1 dash connected, leave the pc off till you get it to run, make sure the loom ecu etc is of a FZ1 not a R1, what have you done with the fuel pump system the bike will not start without this connected...
crack in frame
I didnt notice the crack in my frame until i put the bike on the trailer and pulled it down with tie downs, the rear tiedown went through the rear sub frame and pulled it backwards. With only moderate pressure the crack could be seen, letting the tiedown loose the crack would...
shock
Hi Brenden
I have a std shock for a 07 FZ1 in good conditionyou can have for $50, im in Mittagong nsw i go to sydney every day for work so might be able to drop it in?
Peter
After you have undone the plug use a 12inch length of rubber hose to fit over the plug to help with screwing it out as well as in, if the plugs are new tighten them up then undo them 1/2 turn, tighten them up again and the crush washers will then seat better
Hi There
If like me you have found your Fazer a bit lazy in the steering department, i have just discovered a easy fix to increase the rear ride height by 25mm. This will quicken up your steering without being to radical or adding to much to the seat height. The rear suspension link ( long...