Recent content by Mandelmassa

  1. Mandelmassa

    Bridgestone T30 EVO

    Just left my bike at the mechanic to put a t30 evo on the front as well. Changed at the rear last autumn. See if I can feel a difference on the front as well. Had pr4 before Skickat från min D6503 via Tapatalk
  2. Mandelmassa

    Bogie's FZ10 Build Thread

    So even the mt10 has the snatchy throttle issue... Why does yamaha always tend to have this issue when most other manufacturers seems to solve this Skickat från min D6503 via Tapatalk
  3. Mandelmassa

    IVAN ECU Flash: Dynochart Air/Fuel

    Maybe you received a fuel map for a full exhaust system, not decat? Skickat från min D6503 via Tapatalk
  4. Mandelmassa

    Bogie's FZ10 Build Thread

    Wow, huge improvements. This is the way it should have looked from factory. Does not look cheap anymore. Great work Skickat från min D6503 via Tapatalk
  5. Mandelmassa

    MT-10 Review

    So you did. Missed that :) Skickat från min D6503 via Tapatalk
  6. Mandelmassa

    MT-10 Review

    But you also have the effect of weight bias while seated. As i understand the mt10 is more upright than the fz1 which would put more weight further back while seated Skickat från min D6503 via Tapatalk
  7. Mandelmassa

    MT-10 Review

    So, what is actually making the mt10 that much more wild and wheelie crazy? Looking at dyno charts it seems to be about the same as a normally modded fz1. Is it shorter wheelbase? Shorter gear ratios? Skickat från min D6503 via Tapatalk
  8. Mandelmassa

    FZ1 cutting out at low speeds TPS code 16

    Ok, thanks. Will try this thing next time then Skickat från min D6503 via Tapatalk
  9. Mandelmassa

    MT-10 Review

    No doubt it is a great bike and a blast to ride. It gets great reviews. For me personally I just wish the styling was a bit more conservative, but perhaps it grows on you after a while. Skickat från min D6503 via Tapatalk
  10. Mandelmassa

    FZ1 cutting out at low speeds TPS code 16

    Great, thanks. Much appreciated. When kill switch is on according to those steps, that means it is in the position where you cant start the bike, right? Skickat från min D6503 via Tapatalk
  11. Mandelmassa

    FZ1 cutting out at low speeds TPS code 16

    I thought about doing this, checking my tps. How exactly do I do it? Skickat från min D6503 via Tapatalk
  12. Mandelmassa

    MT-10 Review

    That is my main concern with the mt10, personally I dont like the looks, but the whole bike just feels plastic and cheap, and apparently it is as well. It is like its made out of a block of recycled plastic. The fz1 on the contrary feels like it is made out of a solid block of aluminium. Very...
  13. Mandelmassa

    Had to be done

    Had a ride here in Sweden last sunday. Was almost 4 months ago. Cold as hell, but could not resist after I had done some servicing :) After you been away from it for so long it really strikes you how incredibly fast this thing is!
  14. Mandelmassa

    Open / Close loop mode...

    Ok, that sucks. I thought that might make it more stable at idle going that way, if it now really is the o2 sensor that is the issue. Thats the question... I do have a pc3 laying at home and I am thinking if doing a proper dyno tune with it, but in that case I want to be absolutely sure that...
  15. Mandelmassa

    Open / Close loop mode...

    So, the bike should not get into any "problems" if I unlugged the o2 sensor and put an o2 eliminator in place even though it is ecu flashed with the o2 sensor still active? It will basically become a bit richer in the former closed area than with the o2 sensor active? The rest of the area, the...
Back
Top