Recent content by fz1inMN

My faring is cracked on the left/inside portion of the faring. black. would really appreciate the hook up.

Thanks...but, Thanks bro. I Just gave it a go..took out the 3 screws holding the casing in where the tools sit, and that dang thing isn't going anywhere...I couldn't get it to budge a bit! so ure saying I need to take off the 4 bolts from the tie down pieces, then the 3 or whatever bolts...

So this little 'back off' thing has four wires, which need to be wired into the brake light switch...at least that's my understanding. The directions said to go back at least 6" from light itself...if that's the case, I haven't a clue how to do that, b/c my taillight wires seem quite short and...

Thanks Fellas! Got the mod and harness yesterday, and after an hour and one drilled hole in my fairing for the sensor, it was ready to roll! Now i'm stuck a little on my 'back off' tail light...I will start another thread. Thanks...

have an '01 Fz1, and can't find where to buy a headlight modulator for it, can anybody help me out? thx.

I hope I bought the right thing, is this what you were referring to: Powerstands Air Injection Block Off Plates Yamaha FZS600 FZ6 FZ6R R6 R6S FZ1 R1 | eBay

block plates? Remember, I don't know jack when it comes to this stuff...what are block off plates, where do I get them and how/where do I put them?

Hello all, new to he forum and to Fz's!!! Got my '01 Fz1 about a week ago, and absolutely LOOOOOOOOOVE IT. It is a piece of cake to ride, and far and away the smoothest bike I've ever owned or been on. That being said, it's basically all stocl except a Corbin and windshield. I just...

I just bought an '01' Fz1. It still has the original muffler, and I read another post saying he had to add some additional parts to put on a slip-on. Is this true? Is there a walk-through or possibly a video showing how to do this? I'm not a 'motor head' at all, but I hope to be...

I bought a Corbin seat as an extra to my FZ1 purchase and tried to install it yesterday. Problem being, there is two screws/bolts 1/2 way (between driver/pass.) sticking out and I couldn't figure out for the life of me how I was supposed do tighten this thing down. I checked out some newer...