Recent content by Butthead

  1. B

    Penrite 10Tenths race coolant (red) - Has anyone tried it?

    Probably find that FB groups have taken over from forums to a degree Been running yamaha oem coolant
  2. B

    Engine Rotor - Why has Yamaha not issued a recall?

    Replaced mine at 20,000km, looked like new, I know a couple of guys whose bikes have 60,000 and 120,000 still on the original rotors but there are many more whose have also failed, comes down to risk, if it does go pear shaped its got the potential to cost you
  3. B

    Adelaide Dyno

    Not too many fucks given the day mine went onto the dyno, he did give me a call after he had it for a day to say he had issues with a file on the ECU, and couldn't get it to run properly down low but he did flash it to get rid of the EXUP error msg, as per the PCV, it wasn't suggested when the...
  4. B

    Adelaide Dyno

    I spoke to him at length before both on the phone and I rode down to Elliott to speak to him in person, I did query him on a PC, he told me that he'd have to do a map for that , something he could do through the ECU, took his word for that, chart wise I got bugger all, one with little info on it...
  5. B

    What did you do to your FZ today?

    Bought a radiator guard, better than the plastic excuse thats there now RadGuard Sample pic, still in the post
  6. B

    Adelaide Dyno

    Its hit and miss with a lot of these, what good for some may not be for others, Dicko also from Adelaide uses Lush and gets great results, apart from the low range issues, had the cost been a couple of hundred dollars for the tune and the results aren't forthcoming, it would not have been too...
  7. B

    Adelaide Dyno

    Yes, unfortunately there is a lot to be desired, information wasn't really forthcoming and what was, was questionable, I did msg him feed back which was basically the issues that I mentioned here only to get no response, that in itself speaks volumes. All I can say with regards to this, is that...
  8. B

    Adelaide Dyno

    He gave me one chart, and even that I had to ask for it and he was reluctant, the hp/knh with no rpm readings, no torque chart, gave a crock excuse that his rpm pickup wasn't working, again the issue is that there is no live engine data within the software, apparently they can get access to the...
  9. B

    Adelaide Dyno

    Just an update, as I haven't posted for a while, bought a R77 system and went and spoke to Neville Lush re getting the bike tuned. I queried about getting a PC but he advised against it as he could use Woolich software to flash the ECU and dyno tune it. I went ahead with that, result, no overly...
  10. B

    Anyone here with Pirelli Diablo Rosso III

    Not complaining about the mileage, its just that I've never seen one go this way, normally they wear out until they go smooth if you choose to leave it that long or so with most of the other tyres I've seen. Have a few tightarse mates that get their pound of flesh from tyres. Be getting another...
  11. B

    Anyone here with Pirelli Diablo Rosso III

    Nope, no canvas, just cut up rubber, plus uneven wear where it was down to the wear bars where the "damage" is yet around the other half of the tyre the wear bars weren't flush, got on to Pirelli and GC both of which told me that the tyre is worn and thats the way they go, never seen anything...
  12. B

    Anyone here with Pirelli Diablo Rosso III

    After 8500km my tyre has had it, it's hit the wear bars , do only sports riding, no commuting/touring or track days, good grip, fast heat up but it's started to delaminate, anyone else experience this
  13. B

    Adelaide Suspension

    Well I finally got my suspension done, ended up going to Hoey's who revalved and reshimed the forks plus also got some race tech springs. The back ended going for wilbers 641 with remote and h/l comp adjustment. Just got back from a ride to check it out, chalk and cheese to what it was, money...
  14. B

    Air Filters - K&N - DNA - BMC

    I spoke to the tuner and he uses DNA filters. See what I can get either or for. You guys using BMC, with oiling it, will any brand do or does it have to be filter brand specific. I have a spray can of K&N air filter oil, but it's over 30 years old, wonder if that would be any good Cheers
  15. B

    Air Filters - K&N - DNA - BMC

    Howdy Just picked up a R77 system and looking to replace the stock filter with one of the above. From what I have looked up they breath better but the question is how much crap do the let in or is that negligable and are some better than others. Cheers
Back
Top